View Single Post
Old 07-20-2015, 02:49 PM
keati1 keati1 is offline
Hot Shot
Join Date: Jul 2015
Posts: 21
keati1 has 10 reputation points
Default Avaya 4610SW VPN issue


I am having an issue with one IP address while trying to connect through a VPN tunnel. I have 8 phones that work just fine. Number 9 is giving me issues that I do not understand. When the operating phone connects through the VPN tunnel, it starts off HTTPS: 1 The next thing on the phone is HTTPS 1-1. It does the same for HTTP. Then it goes to TFTP 1 for about 2 seconds, then loads the 46xxsettings.txt and finishes with requesting the extension. Now for the problem phone. When it starts off with HTTPS: 1, the next screen is HTTPS 1-905. The same for HTTP. Then it goes to TFTP 1, but the first number just changes from 1 to eventually 6, before I get TFTP Error: Timed Out, after which it goes to Discover

My question is (and I am very new at this) is there somewhere in either the ASA or PBX that I need to enter or enable the IP address for the problem phone, so that it will do the connection normally. I have done two phones, side by side, connected to the same Cisco PIX with the same settings, but different phone IP addreses, but something is stopping the process for the second phone Clearly both phones are reading the same 46xxupgrade.scr, but from there things go astray.

Can anyone help me?
Reply With Quote