View Single Post
  #3  
Old 04-22-2014, 12:28 AM
patil68 patil68 is offline
Aspiring Member
 
Join Date: Mar 2014
Posts: 2
patil68 has 10 reputation points
Default

Dear Team,

Please find the following config of trunk group. The incomming calls are getting dropped after 2-3 mins. Please help.

TRUNK GROUP

Group Number: 2 Group Type: co CDR Reports: y
Group Name: test COR: 1 TN: 1 TAC: 802
Direction: two-way Outgoing Display? n
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 0 Country: 9 Incoming Destination: 300
Comm Type: voice Auth Code? n Digit Absorption List:
Prefix-1? y Trunk Flash? n Toll Restricted? y

Trunk Type: loop-start




Group Type: co Trunk Type: loop-start

TRUNK PARAMETERS

Outgoing Dial Type: tone Cut-Through? n
Trunk Termination: rc Disconnect Timing(msec): 500

Auto Guard? n Call Still Held? n Sig Bit Inversion: none
Analog Loss Group: 6 Digital Loss Group: 11
Trunk Gain: high

Disconnect Supervision - In? y Out? y Cyclical Hunt? n
Answer Supervision Timeout: 10 Receive Answer Supervision? n
Administer Timers? y
XOIP Treatment: auto


TRUNK FEATURES
ACA Assignment? n Measured: none
Maintenance Tests? y
Data Restriction? n

Abandoned Call Search? n
Suppress # Outpulsing? n

Charge Conversion: 1
Decimal Point: none Replace Restricted Numbers? n
Currency Symbol: Replace Unavailable Numbers? n
Charge Type: units Receive Analog Incoming Call ID: Bellcore
Per Call CPN Blocking Code:
Per Call CPN Unblocking Code:

Outgoing ANI: Ds1 Echo Cancellation? n



ADMINISTRABLE TIMERS
Send Incoming/Outgoing Disconnect Timers to TN465 Ports? n
Incoming Disconnect(msec): 500 Outgoing Disconnect(msec): 500
Outgoing Dial Guard(msec): 1600
Incoming Glare Guard(msec): 1500 Outgoing Glare Guard(msec): 1500


Ringing Monitor(msec): 5200 Incoming Seizure(msec): 320
Outgoing End of Dial(sec): 10 Outgoing Seizure Response(sec): 5
Programmed Dial Pause(msec): 1500
Flash Length(msec): 540
Busy Tone Disconnect? y




END TO END SIGNALING
Tone(msec): 350 Pause(msec): 150

OUTPULSING INFORMATION
PPS: 10 Make(msec): 40 Break(msec): 60 PPM? n



ATMS THRESHOLDS
TTL Type: 105-w-rl Far End Test No:
TTL Vendor: TTL Contact:
Trunk Vendor: Trunk Contact:
Trunk Length:
MARGINAL UNACCEPTABLE
Min Max Min Max
1004 Hz Loss: -2 21 -2 21

-Dev +Dev -Dev +Dev
404 Hz Loss: 9 9 9 9
2804 Hz Loss: 9 9 9 9

Maximum C Message Noise: 55 55
Maximum C Notched Noise: 74 74
Minimum SRL-HI: 0 0
Minimum SRL-LO: 0 0
Minimum ERL: 0 0

Allow ATMS Busyout, Error Logging and Alarming? n



TRUNK GROUP
Administered Members (min/max): 1/5
GROUP MEMBER ASSIGNMENTS Total Administered Members: 5

Port Code Sfx Name Night Mode Type Ans Delay
1: 001V201 MM711
2: 001V202 MM711
3: 001V203 MM711
4: 001V204 MM711
5: 001V205 MM711
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:



Thank You,
Abhisar.
Reply With Quote