View Single Post
  #2  
Old 11-21-2013, 01:21 AM
markgallagher markgallagher is offline
Legend
.
 
Join Date: May 2010
Posts: 588
markgallagher has 25 to 49 reputation pointsmarkgallagher has 25 to 49 reputation pointsmarkgallagher has 25 to 49 reputation pointsmarkgallagher has 25 to 49 reputation points
Default

?? Impedance matching is not something that runs continuously. Its only used when you select to run it in Manager and then its finished. Incorrect impedance values would most likely show up in call quality (bad echo) rather than failure to actually seize the line. So unlikely to be the problem.

Can the system receive incoming calls on those line?

What mode is the system running in (Basic Edition or other)?

What level of software?
Reply With Quote