View Single Post
  #1  
Old 02-03-2015, 12:53 PM
mbong mbong is offline
Hot Shot
 
Join Date: Aug 2012
Posts: 12
mbong has 11 reputation points
Question Renewing VPN Phone Certificate SCEP - MYCERTRENEW 9611G and 9630G

Hello,

We have VPN phones working well configured for user authentication along with a device certificate downloaded to the phone upon programming. The certificate is obtained using the Simple Certificate Enrollment Process (SCEP) from an MS Certificate Authority server.

We have this setup configured with 4621SW, 9630G (3.10S fw) and 9611G (6.3037 fw) phones. We currently reprogram phones with a new device certificate when one expires. However, there seems to be a way to automatically renew the certificate on 96x0 and 96x1 phones as evidenced by this parameter found in the settings.txt file:

## MYCERTRENEW specifies the percentage of the identity certificate's
## Validity interval after which renewal procedures will be initiated.
## Valid values are 1 through 99; the default value is 90.
## This parameter is supported by:
## 96x1 H.323 R6.0 and later
## 96x1 SIP R6.0 and later
## 96x0 H.323 R3.1 and later
## 96x0 SIP R1.0 and later
## SET MYCERTRENEW 90

I have opened tickets with Avaya and have not been able to receive much information on this. Based on firmware change-logs for these set types, it is supposed to work, but there doesn't seem to be any documentation specifically regarding the exact way this works.


Has anyone gotten this to work and/or can shed light on the following questions I have?

- When the phone initiates the renewal procedure, can the requests be seen on the MS certificate server? If so, where can we see this?
- How often does the phone initiate the procedure before it is successful and/or does it stop after a certain point of failure?
Reply With Quote