View Single Post
  #1  
Old 01-10-2013, 01:22 AM
badozc badozc is offline
Member
 
Join Date: Feb 2012
Location: Switzerland, Geneva
Posts: 7
badozc has 10 reputation points
Post R2 MFC in Mexico with Telmex, CLI issue

Hello Dear Community

I recently implemented a site in Mexico on ACM 6.0.1 with a G430 and MM710.
Service provider is Telmex and the PSTN connection is a CAS R2 MFC with 10 channels.
The trunk is up and running quite well except that we do not receive calling party number on the trunk for incoming calls. The customer says that it was working on its former Panasonic PBX.
Altough I received some setup recommendation from Avaya and applied them we still do not have CLI but they were helpful to get the trunk up.
I have no knowledge about R2 MFC, I work from Europe and this is not popular nowadays and it is more than hard to get support from the Service Provider.

Any guidelines to set up or methodology to troubleshoot this type of line are welcome.
Regards

Here is the multifrenquecy table I am using :







Attached Images
File Type: jpg Multi_Page_01.jpg (46.2 KB, 124 views)
File Type: jpg Multi_Page_02.jpg (31.8 KB, 106 views)
File Type: jpg Multi_Page_03.jpg (32.6 KB, 102 views)
File Type: jpg Multi_Page_04.jpg (39.7 KB, 104 views)
Reply With Quote