View Single Post
Old 10-15-2015, 10:39 AM
tgruber tgruber is offline
Hot Shot
Join Date: Jul 2014
Posts: 22
tgruber has 14 reputation pointstgruber has 14 reputation points

The L3 section of the running-configuration only shows stuff used for routing (not mgmt adresses).
the Switch should use the default gateway with no problems if the gateway is inside the subnet of the IP Address. You should be able to use the following command to set the address and gateway in one go:
ip address x.x.x.x netmask y.y.y.y default-gateway z.z.z.z
Also is the mgmt vlan set correctly? With ip routing disabled (which should be the state of the switch if you route VLANs elsewhere) the switch only has an IP Address in the mgmt VLAN. You can set that thusly (xxxx is your mgmt vlan id):
vlan mgmt xxxx
Reply With Quote