View Single Post
  #1  
Old 06-09-2017, 01:21 AM
marge2 marge2 is offline
Aspiring Member
 
Join Date: Sep 2014
Location: Bedford UK
Posts: 2
marge2 has 10 reputation points
Question Connection to Multitone Access 3000

Hi can anyone help?
I am trying to connect a Communications Manager Vsn 6.3 to a Multitone Access 3000 paging system.
This is an old paging system so the connection is using analogue trunks (MM711 in G450).
CM trunk type is set as CO with Tone Dialling.
I can connect using the TAC & see the connection being made using List Trace TAC but instead of getting the expected welcome message I am just getting dial tone!
I can dial over the tone to enter the expected details (pager number & numeric message - in this case call back extensions) but I can only get 6 of the expected 8 digits to be recognised & then the paging system comes back with "Error, Invalid Message"
I an going over just about all legal trunk group settings but any detected changes in behaviour are always for the worse...
This is driving me mad
Reply With Quote