How to know CCM mode from SAT

[kmoham]

Hello,

Is there any command done on SAT to know if CM is embedded, simplex or duplex ?

Regards,
KT

[dupl7]

The easiest would be on the web page, if you can login to SAT you should be able to use same credentials and login to web page.

On the web page you would also be able to get Server hardware information etc..

The other way would be from the shell, but there would be a couple of commands to run to get relevant information

[richa164]

if you type "go shell" from sat then "server" from the shell you get this info

[rossmitch]

Being able to login to SAT doesnt always mean you can login to the web interface or have permission to view server type.

Not all login accounts can do a go shell command (usually prof18 cant), however the server command is the easiest way as it shows if you have one or two servers, however keep in mind that wont show you the difference between an embedded server or a simplex server.

[mlombardi1]

Console Domain web interface will display what CM template is installed. Easy way to distinguish between embedded and simplex.