![]() ![]() |
#1
|
|||
|
|||
![]()
If the caller hangs up the call, the call is ended on the caller side but the call stays up on the PABX side. After running a trace, I can see that there is no BYE message.
I cannot find any option in the SBC that could be blocking the BYE message. I know it is not a carrier issue as it worked fine when the SIP trunk was connected directly to the PABX If the PABX handset hangs up the call, then both legs hangup just fine. |
#2
|
|||
|
|||
![]()
who is ending the call and where is the bye missing? can you post a tracesbc?
regards, andre |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|