- Transfer Mode. Select the mode to be used. You can choose from Blind, Partial or Full. The default is Blind.
- Transfer Prefix Code. Enter the code which prefixes a call transfer, if required by the PBX. The code can be DTMF, or a combination of the letters A through D, H, N, T, X, P, M, and R, and the special characters pound (#), asterisk (*), dash (-), comma (,), plus sign (+) and ampersand (&). You can enter up to 99 characters.
- Transfer Completion Code. Enter the code that completes a call transfer, if required by the PBX. The code can be DTMF, or a combination of the letters A through D, H, N, T, X, P, M, and R, and the special characters pound (#), asterisk (*), dash (-), comma (,), plus sign (+) and ampersand (&). You can enter up to 99 characters.
- Transfer Release Code when Busy. Enter a transfer release code for a busy extension, if required by the PBX. The code can be DTMF, or a combination of the letters A through D, H, N, T, X, P, M, and R, and the special characters pound (#), asterisk (*), dash (-), comma (,), plus sign (+) and ampersand (&). You can enter up to 99 characters.
- Transfer Release Code when No Answer. Enter a transfer release code for a ring-no-answer extension, if required by the PBX. The code can be DTMF, or a combination of the letters A through D, H, N, T, X, P, M, and R, and the special characters pound (#), asterisk (*), dash (-), comma (,), plus sign (+) and ampersand (&). You can enter up to 99 characters.
- Transfer Release Code when Reject. Enter a transfer release code for an extension rejection call, if required by the PBX. The code can be DTMF, or a combination of the letters A through D, H, N, T, X, P, M, and R, and the special characters pound (#), asterisk (*), dash (-), comma (,), plus sign (+) and ampersand (&). You can enter up to 99 characters.
- Flash Time Interval (ms). Enter the time, in milliseconds, that the hookswitch must be pressed for the voice mail system to recognize it as a hookswitch flash signal. The range is 0 through 10000.
- Enable Call Progress. Select to enable full call progress. When selected and a call is placed to an extension, the system listens for busy, invalid number, no answer and connect signals. If not selected and a call is placed to an extension, the system assumes answer. This check box is selected by default.
|
Note:
This property may be overridden by other applications when placing an outbound call.
|
- Start Delay for Call Progress. Enter the duration, in milliseconds, between dialing a number and starting call progress. The range is 0 through 5000.
