Configuring the telephony interface for QSIG or Set Emulation (MAS Admin)

Use the Telephony Interface (QSIG or Set Emulation) property pages to configure ports.

In the Voice Mail System Configuration window, choose Message Application Servers.

Choose the MAS you want to configure.

Select Telephony Interface.

Tip: To make the QSIG or Set Emulation telephony interface active, click on the down arrow

and select Make Active. If the QSIG or Set Emulation telephony interface is already active, this field does not appear.

The General (QSIG or Set Emulation) Telephony Interface property page is displayed

Note: The Agent Based ACD property page is available only with NT M-1 switches using Set Emulation. For more information see Configuring Automatic Call Distribution (ACD).

In the Playback Volume field, enter a value for the playback volume. The range is –8 through 8 and the default is 2. It is recommended that you enter 2 for 30-port, 24-port, 8-port or 4-port cards.

In the Concurrent Calls field, enter the number of ports that connect the MAS to the PBX. The default is set during installation. The range is from 0 to 999.

In the Ports field, check the check box next to the port number to enable the port. Clear the check box to disable the port. All ports are enabled by default.

In the Extension Number field, enter the extension number associated with the MAS port. The extension number is required only if you are using linear chain integration with Set Emulation. You can enter up to ten digits. The Extension Number field is available only with set Emulation.

Note: The Extension Number field is not available with the QSIG telephony interface.

Click OK.

Configuring the telephony interface for QSIG or Set Emulation

To configure Telephony Interface properties (QSIG or Set Emulation)