|
|
|
Identifies a load threshold table to be used for a specific set of prefixes.
load use-threshold-table <name> no load use-threshold-table
Must be in engine or policy configuration mode (config-engine or config-engine-policy), which require privileged-level access.
Use once globally, or once per decision policy.
For decision policies, use the globally defined table.
Globally, there is no default--a configured table is required if load optimization is enabled.
The load use-threshold-table command specifies which configured table to use globally or for a specific decision policy. (You must use the resync load threshold-table command first; an attempt to use a table that has not been committed will be rejected.)
For more information about the load optimization process, see Chapter 2: WAN Cost and Load Optimization in the CNA Adaptive Path Controller Guide.
Also see the load threshold-table command.
|
|
|