|
|
|
Enables always-move-from-bgp behavior when a service outage occurs on a BGP-selected route.
outage-detection always-move-from-bgp no outage-detection always-move-from-bgp
Must be in engine or policy configuration mode (config-engine or config-engine-policy), which requires privileged-level access.
always-move-from-bgp behavior is disabled (BGP’s selection prevails, even though CNA has determined there is a service outage)
By default, CNA is reluctant to move traffic away from a BGP-selected route for any reason other than a measured improvement in performance.
Use the outage-detection always-move-from-bgp command to remove this reluctance. When this behavior is enabled, CNA will remove the BGP-selected route from the winner set used in recomputing a performance route after a service outage has been detected on a BGP-selected route.
When configured from engine mode, the command is applied globally, to all prefixes.
When configured from policy mode, the command is applied only to those prefixes which are associated with the policy.
Use the no form of the command to disable the always-move-from-bgp behavior, thereby reinstating the reluctance to move away from a BGP route.
|
|
|