|
|
|
Provides the CNA link monitor with contact information needed to poll an SNMP agent on a remote device for link usage and BGP and interface status.
polling snmp-agent <name> no polling snmp-agent <name>
To create an SNMP configuration block, you must be in configuration mode (config), which requires privileged-level access.
To associate the configuration block with a service provider link, you must be in link configuration mode (config-engine-link), which requires privileged-level access.
You will need to add a block of SNMP configuration commands for each device that is to be polled, then you will need to associate the block with the edge router on which the link is configured. You can also have a separate block of configuration commands for an SNMP agent dedicated to BGP status polling.
Enter configuration mode (config) to create the configuration block using the polling snmp-agent command. The name argument of the polling snmp-agent command should be a unique string that meets the criteria described in the section Legal Characters in Chapter 1: Introduction to the Command Line Interface.
This will place CNA into SNMP-polling configuration mode (config-polling-snmp), which will allow you to use the following commands to set the following parameters:
When you have configured the parameters, exit out of config-polling-snmp mode and enter link configuration mode (config-engine-link) for the link that represents the same service provider.
Enter the polling snmp-agent command again, with the same name argument.
Then continue configuring the link with the following commands:
See the polling bgp-status snmp-agent command.
|
|
|