|
|
|
Identifies an SNMP agent on an edge router to be used for BGP status polling.
polling bgp-status snmp-agent <name> no polling bgp-status snmp-agent
Must be in link configuration mode (config-engine-link), which requires privileged-level access.
Use the polling bgp-status snmp-agent command to associate a block of SNMP configuration commands with a link.
These SNMP commands are created in config mode with the polling snmp-agent command, to provide CNA with the information it needs to communicate with an SNMP agent on an edge router.
If you do not use the polling bgp-status snmp-agent command, CNA will poll the same SNMP agent for BGP status that it polls for link usage.
You will also need to add the IP address of the SNMP agent to the link configuration.
See the polling bgp-status interface-ip-address and polling snmp-agent commands.
|
|
|