|
|
|
Sets a flag used by the CNA decision maker process when determining the status of a link.
require-bgp-snmp-poll no require-bgp-snmp-poll
Must be in engine configuration mode (config-engine), which requires privileged-level access.
When require-bgp-snmp-poll behavior is enabled by adding this command to the CNA configuration, the CNA decision-maker process will immediately stop route-assert mode if the CNA link monitor process reports the status of the BGP peering as unknown consecutively a user-specified number of times. This number is set by the polling bgp-status unknown-threshold command.
The behavior is disabled by default because of its dependence on SNMP, which must be running on your edge router.
Once you have enabled SNMP and configured the CNA link monitor, you can add the require-bgp-snmp-poll command to your CNA configuration. For additional information about this behavior, see Chapter 3: Adaptive Path Control of the CNA Adaptive Path Controller Guide.
See the polling bgp-status on command for information about CNA link monitor and SNMP polling.
Use the no form of the command to disable require-bgp-snmp-poll behavior.
|
|
|