|
|
|
Sets duplex mode for an interface.
duplex [ full | half ] no duplex
Must be in interface configuration mode (config-if), which requires privileged-level access.
The duplex command with no keyword sets the mode to auto.
Both duplex and speed of an interface can be configured, but they are dependent on each other. If any one of them is set to auto, then both will be implemented as auto regardless of the setting of the other.
Changing either duplex or speed will bring the interface down and back up and you will lose Telnet or SSH connectivity. Changes to these modes should be done from a serial port connection.
See the speed command.
|
|
|