efc bytes minimum

Specifies a minimum amount of traffic volume for IP addresses sent to an active measurement group by the optional EFC module.

efc bytes minimum <number>
 
no efc bytes minimum
 

• number--number of bytes

Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.

Use once per active-measurement group.

Zero

Use the efc bytes minimum command to specify a minimum amount of traffic volume for IP addresses added to an active measurement group by optional EFC module. Endpoints that did not transfer the number of bytes specified by number will not be added to the group.

The efc bytes minimum command is one of several commands which place restrictions on which endpoints obtained from the EFC module will be probed. See also:

• efc bytes top
• efc last-update-within
• efc exclude-prefix
• efc source

You can use them together in the same active measurement group.

Use the no form of the command to remove the minimum bytes restriction from the active-measurement group configuration block.

For more information about EFC, see Chapter 2: Collecting Endpoint Addresses of the CNA Basic Monitoring Guide.