DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Add IP Solutions

Replace the Cables

Return to Task List

  1. Disconnect the network cable from the Ethernet connection.

  2. Turn off the modem and unplug it from the AC outlet. It is not needed for the TN2302AP.

  3. Disconnect the modem's RS232 port from the H600-512 external cable assembly.

From the rear of the cabinet:

  1. Disconnect the amphenol connector on the external cable assembly from the backplane connector corresponding to the TN802B circuit pack.

  2. Connect the amphenol connector on the TN2302AP Amphenol adapter to the backplane connector corresponding to slot selected for the TN2302AP circuit pack.


Note: The TN802 circuit pack occupied 3 slots, and the cable was connected to the rightmost slot. For convenience use the same rightmost slot vacated by the TN802 circuit pack for the TN2302AP circuit pack. The other 2 slots are now available for other circuit packs.

  1. Connect the network cable to the Ethernet connector on the TN2302AP Amphenol adapter.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.