Verifying the Data Transfer

To verify that the customer database transferred correctly:

1. Start at the Avaya Intuity Main Menu and select:

TCP/IP Administration
	Networking Addressing


 


Note: The system might not have networking. If not, you can skip these steps and go to Step 7.

2. The system displays the Networking Addressing Window.
3. Compare the values on this screen to the values recorded earlier during this upgrade in the table TCP/IP Administration Screen Contents in Technician's Upgrade Worksheet.


 


Note: The TCP/IP Interface field is completed for you. To check the entry, press F2 (Choices) to display the available entries.

4. Do one of the following:
• If the values are correct, press F6 (Cancel) and go to Step 7.
• If the values are incorrect or are not displayed, move the cursor to each field and enter the values.
5. Press F3 (Save) after making the entries.
6. Press F6 (Cancel).
7. Start at the Avaya Intuity Main Menu and select:

Feature Options

The system displays the Feature Options (Read Only) Screen.


 


Note: Press the UP ARROW key to display voice_ports.

8. Confirm that the Intuity AUDIX system has at least the same features activated in the same quantities as before the upgrade. Compare the features on this screen to the values recorded earlier in the table Existing Customer Features in Technician's Upgrade Worksheet.


 


Note: The customer might have purchased more features or capacity than were displayed on the old system.

9. Press F6 (Cancel).
10. From the Intuity AUDIX Main Menu, select:

AUDIX Administration

11. At the enter command: prompt, enter list mea feat day

The system displays the Feature Daily Traffic Screen.

12. Compare the local and remote subscriber amounts to the values recorded earlier in the table Subscriber Totals in the Technician's Upgrade Worksheet section.
13. Press F1 (Cancel) and enter exit
14. From the Intuity AUDIX Main Menu, select:

Voice System Administration
	Number Services
		Display Services

The system displays the Display Number Services Window.

15. Determine whether the Service Name: column has an AUDIX entry and then do one of the following:
• If AUDIX is displayed, press F6 (Cancel) and go to the next task.
• If AUDIX is not displayed, press F6 (Cancel) and continue with the next step.
16. From the Number Services menu, select:

Assign Service

The system displays the Assign Number Service Window.

17. Press the DOWN ARROW key to move to the Service Name field and press F2 (Choices).

The system displays the available options on the new system.

18. Select AUDIX and press ENTER.

The system displays the Assign Number Service Window with AUDIX displayed in the Service Name: field.

19. Press F3 (Save) and then press F6 (Cancel) twice.

http://www.avaya.com Avaya UCS Information Development