Removing Power from the MAP/40P

The MAP/40P requires a dedicated circuit with a dedicated circuit breaker. The power cord connects to the rear of the MAP/40P at the point labeled AC input receptacle. See the Back View of the MAP/40P. Before you begin any work in the MAP/40P you must disconnect the incoming power.

To remove power:

1. Shut down the system.
2. Turn off the monitor's power switch.

The green or amber lamp on the front bottom of the monitor should be off.

3. Turn off the power switch on the front of the MAP/40P.

The green lamp, labeled POWER ON, on the front of the unit should be off.

4. Unplug the MAP/40P from the power outlet.
5. Remove the MAP/40P power cord from the AC input receptacle on the rear of the MAP/40P.

Removing the Dress Cover

The dress cover provides protection for the internal components of the MAP/40P. You must remove the dress cover to access these components. See the Back View of the MAP/40P.

 

Shut power off before removing the dress cover or access panel of the MAP/40P.

To remove the dress cover:

1. Ensure that the MAP/40P tower configuration is in an upright position on the support base.
2. Remove the six screws located along the bottom of the MAP/40P.

There are three screws on each side of the MAP/40P.

3. Remove the screw holding the dress cover to the rear of the MAP/40P.
4. Remove the front bezel by pulling it forward.
5. At the rear of the MAP/40P, pry both sides of the dress cover away from the unit.


 


As more of the dress cover is removed, it may begin to collapse inward from the pressure.

6. Slide the dress cover up and then forward to remove it from the MAP/40P.

Replacing the Dress Cover

To replace the dress cover:

1. Slide the dress cover into position.
    
   

   Note: Be careful not to catch any cables in the dress cover.

2. Replace the screw holding the dress cover to the rear of the MAP/40P.
3. Replace the six screws along the sides of the MAP/40P.

Restoring Power to the MAP/40P

The MAP/40P requires a dedicated power line.The power cord connects to the rear of the MAP/40P at the point labeled input receptacle. See the Back View of the MAP/40P.

To restore power to the MAP/40P:

1. Place the MAP/40P power cord in the AC input receptacle on the rear of the unit.
2. Plug the MAP/40P power cord into the designated power outlet.
3. Turn on the power switch on the front of the MAP/40P.

The green lamp, labeled POWER ON, on the front of the unit should be lit.

4. Turn on the monitor's power switch.

The green or amber lamp on the front bottom of the monitor should be lit.

http://www.avaya.com Avaya UCS Information Development