Attaching the External Disk Cartridge Drive

To attach the external disk cartridge drive to the old system:

1. Remove the external disk cartridge drive from the RUK.
2. Determine which type of external disk cartridge drive the RUK contains, for example, either an External JAZ Disk Cartridge Drive or an External Magneto-Optical (MO) Disk Cartridge Drive.
3. Do one of the following:
• If the RUK contains an External JAZ Disk Cartridge Drive:
• Set the SCSI ID to 5. Use a pointed tool to increase or decrease the SCSI ID by clicking the + or – switches. See External JAZ Disk Cartridge Drive Settings.
• Confirm that the termination switch is set to 1, which is pushed to the left side. This might require the use of a flashlight. See External JAZ Disk Cartridge Drive Settings for more information.
• Turn off the external drive power switch by setting the power switch to 0 or off. This switch is located at the back right side of the drive.
• Continue with Step�4.
• If the RUK contains an External Magneto-Optical (MO) Disk Cartridge Drive:
• Set the SCSI ID to 4 by turning the SCSI ID setting arrow to point to 4. See External Magneto-Optical (MO) Disk Cartridge Drive Settings for more information.
• Set the four Option Settings to ON. See External Magneto-Optical (MO) Disk Cartridge Drive Settings.
• Turn off the external disk cartridge drive power switch. This switch is located at the back of the drive in the upper left corner. See the External Magneto-Optical (MO) Disk Cartridge Drive Settings.
• Continue with Step�4.
4. Confirm that the Intuity AUDIX system is completely powered down.
5. Find the SCSI port on your platform.

The SCSI port is most likely found at or near the standard location shown in External SCSI Connectors, except MAP/100P or MAP/100P External SCSI Connector.

6. Remove the external SCSI terminator, if one exists, from the system SCSI connection.
7. Determine which of three cables from the RUK to use to connect the external SCSI connector to the external cartridge drive. Depending on the external disk cartridge drive, the SCSI port is one of three types shown in either Cables for External JAZ Disk Cartridge Drive or Cables for External MO Disk Cartridge Drive.
8. Connect one end of the cable to the upper SCSI connector on the back of the external cartridge drive. See either External JAZ Disk Cartridge Drive Settings or External Magneto-Optical (MO) Disk Cartridge Drive Settings.
9. Attach the other end of the cable to the external SCSI connector on the old system.
10. Connect the external drive to electrical power and turn on the power switch. This switch is located at the back right side of the drive.
     
    

    Note: The external drive must be turned on before you can turn on the power for the Avaya Intuity system.

http://www.avaya.com Avaya UCS Information Development