Installing the SCSI Interface Circuit Card in the MAP/40 System

 

Note: This task is used only with old MAP/40 systems that do not have an external SCSI connection. If the MAP/40 system has an external SCSI connection or if the old system is not a MAP/40, skip this task and go to the next task.

To install the SCSI interface card from the RUK in the MAP/40 system:

1. Look in the back of the system at the second slot from the top and then do one of the following:
• If an external SCSI connection exists, go to the next task.
• If an external SCSI connection does not exist, go to Step 2.
2. Remove the dress cover from the front of the system.
3. Remove the four screws from the bottom of the system that retain the dress cover, and then remove the dress cover.
4. Loosen the screws retaining the circuit card cage cover, and then remove the cover.


Observe proper electrostatic discharge precautions when you handle computer components. Wear an antistatic wrist strap that touches your bare skin and connect the strap cable to an earth ground. For detailed electrostatic discharge instructions, see Protecting Against ESD Damage on the Intuity Messaging Solutions Release 5 Documentation for Technicians CD-ROM, 585-313-807.

5. Locate the SCSI interface circuit card and then remove the system cables from the SCSI interface card.
6. Remove the circuit card retaining screw.
7. Gently remove the SCSI interface circuit card from the MAP/40 system.
8. Remove the SCSI interface circuit card from the RUK and then take it out of the antistatic bag.
9. Insert the SCSI interface circuit card in the open slot.
10. Connect the system cables.

http://www.avaya.com Avaya UCS Information Development