Installing the Upgrade Backup Software on the Old System

This task installs the Release 5 upgrade package on the old machine. The package backs up to the external disk cartridge drive instead of to the tape cartridge drive.

To install the upgrade software on the old system:

1. If you are using an A/B switch with a single monitor, switch to the old system.
2. Log in as craft
3. Locate the tape labeled "Upgrade Software" in the RUK.
4. Open the tape drive door.
5. Insert the tape cartridge and close the door. See Inserting a Tape Cartridge.
6. From the Avaya Intuity Main Menu, select:

Customer Services/Administration
	System Management
		UNIX Management
			Software Install
				Tape Drive

The system displays the following message:

Insert cartridge into tape drive 1. Type [go] when ready or [q] to quit:

7. Press ENTER to continue.

The system displays the following message:

Select the packages you wish to process (or 'all' to process "All" packages)


 


Note: All is the default.

8. Press ENTER to install all packages on the tape.

The system installs the software and then displays the following message:

Installation of Intuity Upgrade Software [software] was successful.

Processing of [Intuity Upgrade Utility] is complete.

Insert cartridge into tape drive 1. Type [go] when ready or [q] to quit

9. Enter q
10. Press F6 (Cancel) until you reach the Avaya Intuity Main Menu. See Main Menu Before Installing the Upgrade Package.
11. Remove the tape cartridge and then return it to the RUK.
12. Press F6 (Cancel) until you log off the system and then log back in as craft
13. Verify that the System Upgrade menu option is displayed on the Avaya Intuity Main Menu. See Main Menu After Installing the Upgrade Package. If the menu option is not displayed, repeat Step 3 through Step 13.

http://www.avaya.com Avaya UCS Information Development