Verifying the Cable Connections

To verify that the cable connections are correct:

1. From the Avaya Intuity Main Menu, select:

Voice System Administration
	Voice Equipment

The system displays the Voice Equipment Window.


 


Note: The third column displays foos if the tip/ring cables are not moved to the new system.

2. From the PHONE column, write down each extension in the order displayed.
3. Press F6 (Cancel) once.

The system displays the Voice System Administration menu.

4. From the Voice System Administration menu, select:

System Monitor

The system displays the System Monitor - Voice Channels Window.

5. Using a telephone handset near the Intuity AUDIX system, dial every extension listed in Step 2.
6. Watch the System Monitor - Voice Channels window to confirm that each channel rings in the same order as it is administered on the Display Voice Equipment window. Confirm also that each channel answers the call.
7. Do one of the following:
• If the channels all ring in the correct order and all answer the call, go to Step 8.
• If any channel does not ring in the correct order or does not answer the call, check the cross-connect field for incorrect wiring. Correct the wiring and return to Step 1.
8. Press F6 (Cancel) twice.

Administering Passwords

Some passwords are not transferred to the new system during the upgrade.

To readminister these passwords:

1. From the Intuity AUDIX Main Menu, select:

Customer/Services Administration
	System Management
		Password Administration
			Assign/Change Password

2. The system displays the Assign/Change Password Window.
3. Press F2 (Choices) to display the password options to change.
4. Select sa and then press F3 (Save).
5. Type y to confirm that you want to change the password for the selected login.
6. Enter a new password from the System Passwords table, in the Technician's Upgrade Worksheet section, at the enter password: prompt. The password must contain only from 6 to 11 alphanumeric characters

The system displays the following message:

Re-enter new password: 

7. Enter the new password again.
8. The system displays the following message:

Password changed for sa.

Hit acknowledge key to continue.

9. Press F1 (Acknowledge Message) to continue.
10. Return to Step 3, substituting the vm password.
11. Press F6 (Cancel) until you reach the Intuity AUDIX Main Menu.
12. Do one of the following:
• If the old system did not have Enhanced-List Administration (ELA), go to the next task, Performing Acceptance Tests.
• If the old system had ELA, select the following from the Intuity AUDIX Main Menu:

	Enhanced-List Manager
		Set Up Enhanced-List System Data

The Set Up Enhanced-List System Data Screen is displayed.

13. Enter vm in the System Login: field.
14. Enter the vm password in the System Password: field.
15. Press F3 (Save) to store the changes.
16. Press F6 (Cancel) twice to return to the Intuity AUDIX Main Menu.

http://www.avaya.com Avaya UCS Information Development