Extension
ID:
The physical ID of the extension port. This parameter is only configurable
with an IP extension. With all other extensions, it is allocated by the
system and therefore not configurable.
Extension:
This is the logical extension number and can be up to 9 digits long.
Caller
Display Type: Default = CallerDisplayOn
Controls the presentation of caller display information. See Caller Display.
Off: Disables caller display.
On: Enables caller display using the caller display type appropriate to the System Locale, see Supported Country and Locale Settings. If a different setting is required it can be selected from the list of supported options.
For an analog extension connected to a fax server or other device that requires the pass through of DTMF tones, select DTMFB. See Configuring Personal Fax Numbers.
Equipment
Classification: Default = Standard
Telephone
Select the type of terminal that is connected to the extension port.
Standard Telephone:
Use for normal telephone extensions.
Paging Speaker:
When enabled this Extension can be used
for connection to a paging amplifier. When the Extension is called, no
ringing is generated and the call is answered immediately. (When returning
this extension back to a standard analog extension the Phone module must
also be rebooted.) Quiet Headset:
IVR Port:
Provides
a disconnect clear signal to the attached device at the end of calls.
This is required by some third party devices. When selected the Disconnect Pulse Width is displayed
and can be adjusted if necessary. Note:
This feature is only configurable when the locale setting is configured
for enu (United States).
Hook Persistency: Default = 100ms