Changing the dialout configuration

To change the dialout configuration:

1. From web administration, go to the Dialout Configuration screen (Configuration Management > Alarm Administration > Dialout Configuration).
2. Select Change Parameters.

   The system displays the Change Dialout Parameters screen. For information about this screen, see Change Dialout Parameters screen.

3. In the Product ID field, enter the 10-digit Product ID.
4. In the Trace On field:
   • Select yes if you want trace activated
   • Select no if you do not want trace activated
5. In the Dialout on field:
   • Select yes if you want the system to dial out when the alarm is generated
   • Select no if you do not want the system to dial out when the alarm is generated
6. In the Maximum Allowable Temperature field, enter a temperature in degrees Celsius.

   The system generates an alarm when the specified temperature is reached.

7. In the Minor Alarms Tracked field:
   • Select yes if you want the system to track minor alarms
   • Select no if you do not want the system to track minor alarms
8. In the Port Used field, select the port to use to dial out.
9. Perform the following steps for each location that the system calls when an alarm is generated.

   Note:
   There are a maximum of three dialout locations. Each dialout location is associated with a group of fields on the Change Dialout Parameters screen.

   1. In the Location ID field, enter a string that identifies the dialout location.
   2. In the Phone Number field, enter the telephone number that the system's modem dials to connect with the modem at the dialout location.
   3. In the Modem Speed field, select the baud rate that the system's modem uses to connect with the modem at the dialout location.
   4. In the Char Size field, select the number of bits per character that the system's modem uses to encode information.
   5. In the Parity field, select the parity of the system's modem.
   6. In the Dialstring field, enter the set of commands that the system's modem uses to connect with the modem at the dialout location.
10. Select Submit.

    The system displays information about the success or failure of the administration attempt.

© 2006 Avaya Inc. All Rights Reserved.