Switch Type
Programmable by	System Manager
Mode	Hybrid/PBX
Idle Condition	Not required
Planning Form	3b, Incoming Trunks: DS1 Connectivity (100D and 100R module)
Factory Setting	4ESS
Valid Entries	Not applicable
Inspect	Yes
Copy Option	No
Procedure	Specify the switch type for a PRI tandem trunk connected to a slot in the control unit: LinesTrunksPRISwitchTypeDial slot no. (1-17)EnterSpecify switch typeEnterBackBack
Switch Identifiers
Programmable by	System Manager
Mode	Hybrid/PBX
Idle Condition	Not required
Planning Form	2c, System Numbering: Line/Trunk Jacks 3b, Incoming Trunks: DS1 Connectivity (100D and 100R Module)
Factory Setting	No value; facility not networked
Valid Entries	No value, 1-20, 21-40, 41-50, 51-60
Inspect	No
Copy Option	No
Procedure	Enter or remove an identifier for one trunk: LinesTrunks or MoreUDPSwNum-SingleDial trunk no.EnterDial switch no. (no value, 1-20, 21-40, 41-50, or 51-60)Enter or DeleteBackBackBack Enter or remove identifiers for a block of trunks: LinesTrunksor MoreUDPSwNum-Block Dial starting trunk in blockEnterDial ending trunk in block EnterDial switch no. (no value, 1-20, 21-40, 41-50, or 51-60)Enter or DeleteBackBackBack

Topics

Description

	Switch Identifiers
	ARS, UDP Routing and Remote Access
	Local Calls Routed to Other Systems
	Network Calls Routed via the Local System

System Programming