- Transfer Mode Select the mode to be used.
- Full The system listens for busy, invalid number, no answer, and connect signals.
- Partial The system listens for busy and invalid number signals.
|
Note:
This should not be used for call transfers.
|
|
- Blind (Default) No call progress analysis takes place.
- Start Delay for Call Progress Enter the duration, in milliseconds, between dialing a number and starting call progress. The range is 0 through 20000, and the default is 6000.
- Initiate Transfer Enter the dial string required to start a transfer. You can enter up to 50 characters. The default is ^KD,L%s for NT M-1 and ^Kk,L%s for G3 switches.
- Initiate Blind Transfer Identifies the dial string required to start an unsupervised transfer. By default the behavior of the Initiate Blind Transfer dial string is the same as the behavior of the Initiate Transfer dial string. If required, you can add characters to control the behavior of this dial string. You can enter up to 50 characters, and the default is %s.
- Complete Transfer Enter the dial string required to complete a transfer. You can enter up to 50 characters. The default is ^KD for NT M-1, and ^Kk for G3 switches.
- Retrieve Call Enter the dial string required to drop a transferring call and reconnect the MAS to the calling party. You can enter up to 50 characters, and the default is ^KA.
- Drop Call Enter the dial string required to drop a call by emulating the Release key. You can enter up to 50 characters. The default is ^KR for NT M-1, and ^Kj for G3 switches.
- Make Call Prefix Enter the dial string required when using an alternate key for outgoing calls. This setting is used mostly for automatic call distribution (ACD) integrations, where outgoing calls are made on a different call appearance than incoming calls. You can enter up to 50 characters, and the default is blank.
