VMSC - VMD - PBX Configuration Dialog Box (QSIG)

This topic describes how to use the PBX Configuration (QSIG) dialog box to configure Private Branch Exchange (PBX) properties, if you are using Q-Signaling (QSIG) cards.

To open the PBX Configuration dialog box:

In the Voice Mail System Configuration window, click the voice mail domain (VMD).

Double-click PBXs. The system expands the node to show all available types of PBX.

Double-click the QSIG PBX. The system displays the PBX Configuration (QSIG) dialog box for the selected VMD.

You can configure properties in the following PBX Configuration (QSIG) tabs:

General Use this tab to set up general PBX options. You can use it to set options for dual tone multi-frequency (DTMF) dialing tones.

See VMSC - VMD - PBX Configuration - General Tab (QSIG).

Transfer/Outcall Use this tab to configure the transfer mode.

See VMSC - VMD - PBX Configuration - Transfer/Outcall Tab (QSIG).

Tone Detection Use this tab to specify the maximum silence before hanging up.

See VMSC - VMD - PBX Configuration - Tone Detection Tab (QSIG).

Outgoing Call Use this tab to set up PBX outgoing call options, including the layer 1 protocol and the number type.

See VMSC - VMD - PBX Configuration - Outgoing Call Tab (QSIG).

Intercom Paging Use this tab to set up PBX intercom paging options. Intercom paging allows callers to page subscribers in the building, if they do not answer their extensions.

See VMSC - VMD - PBX Configuration - Intercom Paging Tab (QSIG).