Web Agent Procedure

To set the switch to load the new software at startup:

1. In the navigation pane, expand the System > Memory folders.
2. Select FEPROM.

The FEPROM Contents Web page is displayed in the content pane (Figure�249).

3. In the Power Up/Reset Image field, select the APP location to which you downloaded the new application software.
4. Select APPLY.

Tip: If you set the Power-up/Reset Image to CARD APP1 or CARD APP2, insert the PCMCIA card that contains a valid software image into the slot of the supervisor before you reset the switch. If the PCMCIA slot does not contain a card or the inserted card does not have a valid software image when you reset the switch, the switch will start up in Boot mode.

To configure the startup image from Boot mode and reset the switch, enter the following commands:

1. Boot> feprom set {app1 | app2}
2. Boot> reset