Enabling IEDR for Hunt Groups

This procedure globally enables IEDR for all ports in all hunt groups on the switch.

Note: All ports that have IEDR enabled, whether they are administratively disabled or enabled, assume the hunt group IEDR setting if they are placed in a hunt group. If a port has IEDR enabled before you place it in a hunt group, the show port internal-error-config command displays the port as IEDR-enabled regardless of the hunt group IEDR setting. However, the port in fact assumes the hunt group IEDR setting (whatever that setting is).

To globally enable IEDR for all ports in hunt groups:

1. Enter Global Configuration mode.

The CLI displays the (configure)# prompt.

2. Enter the following command:

set huntgroup internal-error-shutdown enable

To globally disable IEDR for all ports in hunt groups, enter:

set huntgroup internal-error-shutdown disable