busyout | test | release voip-dsp
Privilege: Configure
Description: busyout | test | release voip-dsp <voip ID>
Initiates a Busyout, Test, or Release (BTR) of the specified VoIP engine.Cur-
rent state and most recent test results is available via the MGP CLI command
"show mm <mmID>"or "show voip parameters <voipID>". The test option will run
only non-disruptive tests if the VoIP engine is not busied out. Status
changes create a SNMP trap. 'Release' option stops any test in progress and
restores the engine to operational state. Only VoIP MM is supported in CLI.
Not supported on T1/Analog/BRI MM's which are controlled by SAT; error mes-
sage will display as such if attempted. Message of PASS or FAIL is shown in
output for tests.
Parameters: <voipid> - slot number where the VoIP Engine is installed. Valid
values are v0 to v4, where v0 means motherboard
Sample Display
MG-001-3(configure)# busyout voip-dsp v1
