Media Gateway - Maintenance CLI Set

Media Gateway - Maintenance CLI Set

Maintenance

These commands are used to perform maintenance on the MGP. Use these commands to display voltages, faults and temp readings. This family of commands is used set/display/change SNMP parameters for the MGP. Commands are also available to upload and download configuration files and to display and reset ISDN links associated with Media Modules.


busyout \| test \| release voip-dsp		Provides the ability to busyout/test/release a VoIP engine.
clear isdn link		Removes a specified ISDN link.
clear snmp trap		Removes one or all trap receivers
copy mgp-config tftp		Uploads the MG configuration file.
copy tftp		Downloads all configuration data to RAM.
set snmp trap		Sets up SNMP trap group reporting.
show faults		Shows active faults.
show isdn bri link		Shows the status of all MM BRI links.
show isdn link summary		Displays summary of ISDN links for MG.
show isdn pri link		Displays status of MM ISDN PRI link.
show snmp		Shows all SNMP trap receivers' setup.
show temp		Shows CPU and DSP temperature.
show tftp status		Shows TFTP command status.
show voltages		Shows power supply status.
test led		Tests the MG's LED operation.