Digital Station Audits Test (#17)

This is a series of six tests that are classified as audits. Messages are sent to the on-board microprocessor to perform the following tests. These audits run only if the station is in-service.

Table 24. TEST#17 Station (Digital) Audits Test �
Error Code	Test Result	Description/ Recommendation
1	ABORT	Switchhook audit timed out.
2	ABORT	ID request fails, health bit returned from voice terminal is bad. Make sure voice terminal is connected and repeat test. If test fails, replace voice terminal and repeat test.
3	ABORT	Look for Error Type 769 logged against DIG-LINE and follow the procedures in the associated footnote. If any additional problems are found, rerun the test.
4	ABORT	Internal system error Resolve any outstanding Media Module maintenance problems. Retry the command at 1-minute intervals a maximum of 5 times.
5	ABORT	Ringer update aborted due to station being in ready-for-service or out-of-service state.
6	ABORT	This port may have been busied out by system technician. Look in the Error Log for Error Type 18 (port busied out) for this port. If this error is present, release the port via release station Make sure that the terminal is connected. Retry the command at 1-minute intervals a maximum of 5 times.
1000	ABORT	System resources required for this test are not available.
1392	ABORT	This port is currently a TTI port and the test will not execute on it. Verify that the port is a TTI port using either the display port command (the display shows that the port is a TTI port) or the list config command (the display shows a "t" for the port). If either list config or display port indicate that the port is not a TTI port, escalate the problem. If both commands indicate that the port is a TTI port, the abort is correct, and no action is necessary.
2000	ABORT	Response to the test was not received in the allowable time period.
	FAIL	Internal system error Retry the command at 1-minute intervals a maximum of 5 times.
	PASS	Station Audits passed. This Digital Port Media Module is functioning properly. If complaints persist, investigate by using other port tests, and by examining the station, wiring, and connections.
Any	NO BOARD	The test could not relate the internal ID to the port. Check to ensure that the board translations are correct. Translate the board, if necessary. Issue the busyout board command. Issue the reset board command. Issue the release busy board command. Issue the test board command. This should re-establish the linkage between the internal ID and the port. If the problem persists, replace the circuit pack.