View IPSI Version results

This screen shows information about the IPSI board(s) you selected on the View IPSI Version screen. The output looks something like this:

In the sample output shown above, HW# refers to the boot version, and FW# refers to the firmware version. If the IPSI board runs in boot mode, then BootMode appears in the FW# field.

If an error is detected when you try to view the cabinet number and carrier ID for one or more IPSIs, one of the following error messages appears:

• No match IPSIs. This message indicates that no IPSIs match the cabinet and carrier numbers you entered on the View IPSI Version screen.

• No match IPSIs to X. This message indicates that no IPSIs match the cabinet and carrier numbers you entered on the View IPSI Version screen. In this message, X indicates the cabinet and carrier number (for example, 1a).

• System error. This message indicates that an error was detected during a system operation.

• IPSI IP address mapping error for .... This message indicates that an error occurred while the system was mapping an IPSI to an IP address. It also identifies the troubled IPSI board.