Technician-Demand Tests: Descriptions and Error Codes

Technician-Demand Tests: Descriptions and Error Codes

Always investigate tests in the order presented in the table below when inspecting errors in the system. By clearing error codes associated with the NPE Audit, for example, you may also clear errors generated from other tests in the testing sequence.

Table 182. Technician-Demand Tests
Order of Investigation	Short Test Sequence	Long Test Sequence	Reset Board Sequence	D/ND*
NPE Audit Test (#50) Note: This Test will ABORT with code 1412
Ringing Application Test (#51) (a) Note: This Test will ABORT with code 1412
Control Channel Looparound Test (#52)	X	X		ND
SAKI Sanity Test (#53) (b)		X	D
Neon Test (#220) (c) Note: This Test will ABORT with code 1412	X	X		ND
*D = Destructive; ND = Nondestructive
1 of 2

Notes:

(a) This is only applicable to Analog Line Media Modules.
(b) The SAKI Sanity Test is run on other Media Modules only when they are reset via the reset board command.
(c) This is only applicable to MM711 Analog Line Media Modules.