None

ABORT

System resources required for this test are not available.

Retry the command at 1-minute intervals a maximum of 5 times.

1005

ABORT

If the Media Module needs to be reset, and if this is an Avaya G700 Media Gateway system, and the DS1 interface Media Module under test is providing timing for the platform, it cannot be reset without major platform disruptions (Note: For this type of system the sync timing source is local to the G700). Set the synchronization timing source to another DS1 interface Media Module located in the same G700 and retest. See Setting G700 Synchronization.

If the Media Module needs to be reset, then set synchronization to another DS1 interface Media Module or the Tone-Clock Media Module and try again. Refer to SYNC (Synchronization) Maintenance documentation.

1015

ABORT

Port is not out-of-service.

Busy out the Media Module.

Execute command again.

2100

ABORT

System resources required for this test are not available.

Retry the command at 1-minute intervals a maximum of 5 times.

1

FAIL

The Media Module failed to reset.

2

FAIL

The Media Module failed to restart.

Execute command again.

If the problem persists, replace the Media Module.

PASS

The Media Module initializes correctly.

Run the short test sequence.

Any

NO BOARD

This is normal if the test is being done when (a) the board is not physically in the system or (b) the system is booting up. Otherwise, there is some inconsistency between the physical configuration and the data kept in the system.

Verify that the board is physically in the system.

Verify that the system is not in a stage of booting up.

Retry the command at 1-minute intervals for a maximum of 5 times.