Navigational Aid for CLI Commands

Table 188 describes a few Command Line Interface commands that you will need to navigate between the processors on the G700.

Table 188. Navigational aid for CLI commands
Command	Purpose	Prompt
super	change to supervisor mode	P330-1(super)# or <MG name>-1(super)#
configure	change to configuration mode	P330-1(configure)# or <MG name>-1(configure)#
session <module #> mgp (from a stack processor session)	open a CLI session on the mgp processor	<MG name>-1(super)#
session <module #> stack (from an MGP session)	open a CLI session on the stack processor	P330-1(super)#
session icc (from an MGP session)	open a CLI session on the S8300 processor	craft@<host name>>
session <#>	open a session on the stack processor in module (i.e. another G700)<#> in the stack	P330-<#>(super)#
exit	close the current session (and revert to the previous session)
<command> help	displays help for <command>

The command-line prompts in an MGP session use the media gateway's name that is assigned when it is configured.

You can telnet to another processor from a current telnet session.