Configure Ethernet Adjuncts screen
Use the Configure Ethernet screen to specify IP addresses and (optional)
SNMP community strings for any Ethernet adjuncts that the Avaya media
servers control, which are connected to the servers over a private LAN.
- A typical configuration includes one or more Ethernet
switches and an uninterruptible
power supply (UPS) unit for each control network. See Configuration
overview for details.
- Specify the SNMP GET and SET community strings only
if you intend to track SNMP alarms using a corporate network management
system. See SNMP operation for details.
To configure the Ethernet switches and UPS units:
- Control Network A. present
for all multi-connect configurations and for IP-connect configurations
that use a private LAN for their control network.
- Select the number of Ethernet switches. 1
is always required. 2 are present if needed to support a large number
of port networks.
- Switch 1 IP address. Required.
Refer to your preinstallation worksheet.
- Switch 2 IP address. Supply
if present.
- Optional. Enter the SNMP GET and SET community strings
for one or both switches as required.
- Control Network B. Present
only for multi-connect high- or critical-reliability configurations.
- Select the number of Ethernet switches. Switch 1
is always required. switch 2 is present if needed to support a large number
of port networks.
- Switch 1 IP address: always required if control network
B is present.
- Switch 2 IP address: supply if present.
- Optional:
enter the SNMP GET and SET community strings for one or both switches
as required.
- Uninterruptible
Power Supply (UPS) units: one unit is used to power the server and Ethernet
switches in each control network.
- Select the number of UPS units present. One unit
is used for to provide emergency power for devices in control network
A. Two
units are present if control network B is present.
- UPS 1 IP address for control network A. Always required.
- UPS 2 IP address for control network B. Supply if
present.
- Optional.
Enter the SNMP GET and SET community strings for one or both units as
required.
- When you finish, click Continue.