I have tried disabling the sync source from CLI. but now Avaya moved all to CM on 6.2.
I have checked System Parameter Features Sync Over IP and it is disabled. I have MAJ ALM on my gateway
show faults
CURRENTLY ACTIVE FAULTS
--------------------------------------------------------------------------
-- Hardware Faults --
+ Clock synchronization signal lost, 07/03-11:19:56.00
Current Alarm Indications, ALM LED is on
--------------------------------------------------------------------------
+ Clock SYNC Primary Fault
These are my Sync Sources=
SYNCHRONIZATION CONTROL: --- Remote ---
SOURCE MM or VoIP STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary VoIP Standby Loss of Signal
Secondary Not Configured
Local v0 Active None
Active Source: v0 Sync Source Switching: Enabled
Done!
I also tried moving it to V0 from CLI. Again non of the SYNC commands work in the MG.
I have checked System Parameter Features Sync Over IP and it is disabled. I have MAJ ALM on my gateway
show faults
CURRENTLY ACTIVE FAULTS
--------------------------------------------------------------------------
-- Hardware Faults --
+ Clock synchronization signal lost, 07/03-11:19:56.00
Current Alarm Indications, ALM LED is on
--------------------------------------------------------------------------
+ Clock SYNC Primary Fault
These are my Sync Sources=
SYNCHRONIZATION CONTROL: --- Remote ---
SOURCE MM or VoIP STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary VoIP Standby Loss of Signal
Secondary Not Configured
Local v0 Active None
Active Source: v0 Sync Source Switching: Enabled
Done!
I also tried moving it to V0 from CLI. Again non of the SYNC commands work in the MG.
