View Single Post
  #3  
Old 08-04-2010, 03:29 AM
wenpingliu wenpingliu is offline
Member
.
 
Join Date: Jul 2010
Posts: 3
wenpingliu has 10 reputation points
Default System restore

1) Connect a PC to the IPO LAN port with IP address 192.168.42.xx. Run IP Office Manager.
2) Using RS232 cable to connect IP500 DTE port and run HyperTerminal to connect. Use AT-X command to erase firmware. Or, press Reset button on the back panel for 30-40 seconds will also erase all. Then, IP500 will search its firmware with BootP protocol and will get its firmware from IPO Manager PC.
3) After get firmware, IP500 should restart with default settings.

Key point, must have PC running IPO Manager and set its IP to 192.168.42.xx, and connect to the IPO LAN port.
Reply With Quote