Limit of ERS8600

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • grossmannma
    Aspiring Member
    • Feb 2011
    • 1

    Limit of ERS8600

    Dear all,

    Has anyone experience with limits of the ERS8600 switch?
    8692SF slot 5/6
    8630GBR slot 2,3,4
    8648GTR slot 8
    SW version 5.1.5.1

    60MLTs and 4 SMLTs
    160 VLANs
    15000 MAC recordings
    300 OSPF routes
    RSMLT
    VLACP and SLPP on every necessary port

    No mulicast, RIP, BGP, no ACLs......

    Our problem:
    In this state - described above - switch runs proper.

    Now I have added three VLANs (197, 1971, 1972) and the CPU and buffer utilization goes up to 100% - after 30 minutes.
    I have deleted this 3 VLANs and it lasts 30 minutes, till switch calms down.
    I have done it a second time for verification and it happens the same.
    It seems, the addition of the vlans and an IP address has no effect.
    But if I add this VLANs to OSPF and RSMLT CPU and buffer utilization raises.

    No log messages.
    Checked routes - proper.
    Case is open 1-2263927122, but no idea.

    Are we running in a limit?

    Best regards,
    Martin
  • mayler
    Hot Shot
    • Jul 2011
    • 23

    #2
    no issues, similar configuration. RSMLT meaning you have IST with another 8600, same configuration correct? So when you say you add the VLANs to the RSMLT, you are referring to the IST Trunk.

    Care to provide a show tech on each of the switches? Or just the relevant config. Also a show ip rsmlt info

    Have you review the release notes for 5.1.5.1 or 5.1.0.0 (known issues).


    I'm curious and would like to help out.

    Comment

    • gross10
      Member
      • Oct 2011
      • 3

      #3
      Hello Mayler,

      Correct identic switch on remote side - support has found no relevant entries in show tech or config.
      CPU and buffer utilization goes up also on second switch, but it seems to be an impact from the "problem" switch.

      Best regards,
      Martin

      Comment

      Loading