Activating the AMIS Feature Parameter Changes

You must run the following audits on the local system to activate the AMIS Analog Networking feature parameters:

• Network-Data Audit
• Subscriber-Data Audit

Network-Data Audit

To run an audit and activate changes:

1. Log in to the INTUITY AUDIX command prompt screen.
   

   The system displays the AUDIX command prompt screen.

2. At the enter command: prompt, type audit network-data.

The system displays the Audit Results screen.

3. Press F3 (Enter) to execute the audit.

The system runs the audit. When the audit is complete, the system displays the outcome of the audit in the Results column, the cursor returns to the command line, and the system displays the following message:

Command Successfully Completed.

4. Enter another administrative command at the enter command: prompt or click Return to Main.

Subscriber-Data Audit

To run an audit and activate any changes made to the System-Parameters Features screen:

1. Log in to the INTUITY AUDIX command prompt screen.
   

   The system displays the AUDIX command prompt screen.

2. At the enter command: prompt, type audit subscriber-data.

The system displays the Audit Results screen.

3. Press F3 (Enter) to execute.

The system runs the audit. When the audit is complete, the system displays the outcome of the audit in the Results column, the cursor returns to the command line, and the system displays the following message:

Command Successfully Completed.

4. Enter another administrative command at the enter command: prompt or click Return to Main.

 

 

 

Top of page