timeout

Sets the amount of time CNA will wait for a response from a remote device.

timeout <time>
 
no timeout
 

• time--amount of time to wait, as follows:
• for SNMP, specify time in seconds; range: 1 through 300
• for active-measurement probes, specify time in milliseconds; range: 0 through 780000

Must be in one of the following:

• SNMP polling configuration mode (config-polling-snmp)
• Active measurement group configuration mode (config-engine-active)

Both require privileged-level access.

1 second for SNMP polling

3000 ms for active-measurement probes

You can use the timeout command in either of the following configuration modes:

• SNMP polling agent (config-polling-snmp)--determines how long the CNA link monitor will wait for an edge router to respond when polling for usage data
• Active measurement group (config-engine-active)--determines how long CNA will wait for active probe targets to respond (regardless of probe type--tcp or icmp)

See the polling snmp-agent command for information about configuring the link monitor for SNMP polling.

See the active-measurement group command for information about configuring active-measurement groups. The group wide timeout command will apply to targets that don’t have their individual timeout arguments set.

Use the no form of the command to reset the value of time to its default.