web-speedup worst-bgp-hrtt-percent

Defines one of the brownout conditions--worst N percent of all prefixes--for the Executive Summary snapshot report.

web-speedup worst-bgp-hrtt-percent <value_1> <value_2>
 
no web-speedup
 
no web-speedup worst-bgp-hrtt-percent
 

• value_1--percentage of prefixes considered poor based on HRTT measurements; range: 0 through 100
• value_2--percentage of prefixes considered very poor based on HRTT measurements; range: 0 through 100

Must be in report configuration mode (config-reporting), which requires privileged-level access.

Use once.

value_1--20

value_2--3

Use the web-speedup worst-bgp-hrtt-percent command to set one of the two criteria used to define poor and very poor performance in the Executive Summary snapshot report. The other piece of information is speed of packet delivery, set by the exec-summary min-bgp-hrtt command.

The values set by this command, plus the minimum HRTT threshold, determine which prefixes are used to calculate the Poor Performance and Very Poor Performance columns of the Executive Summary report.

All prefixes are sorted by HRTT score, and the worst value_1 and value_2 percent are included in the poor and very poor performers columns.

Use the no web-speedup command to reset all executive summary parameters to their defaults, including those set by each of the following commands:

• web-speedup http-turns
• web-speedup improvable min-hrtt-saving
• web-speedup improvable min-percent-improvement
• web-speedup min-bgp-hrtt
• web-speedup worst-bgp-hrtt-percent

Use the no web-speedup worst-bgp-hrtt-percent command to reset only the worst HRTT percentage value to its default.