|
|
|
Specify traffic-source type for IP addresses to be added to an active measurement group by the optional EFC module.
efc source { netflow [ <address> ] | monitor}
no efc source [ netflow [ <address> ] | monitor ]
Must be in active-measurement group configuration mode (config-engine-active), which requires privileged-level access.
Available for use multiple times in the configuration.
Endpoints obtained from all input sources will be probed
Use the efc source command to specify a type of input stream; endpoints gathered by the optional EFC module from the specified source will be probed by the active measurement group.
Specify an IP address with the netflow keyword if you want to identify a Netflow stream from a specific router interface.
Use the monitor keyword to identify SPAN data coming from a switch.
The efc source command is one of several commands which place restrictions on which endpoints obtained from the EFC module will be probed. See also:
You can use them together in the same active measurement group.
Use the no form of the command with no arguments to revert to the default behavior for the active-measurement group.
Use the no form of the command with the netflow keyword to remove the explicit efc source netflow configuration statement for all Netflow sources from the active measurement group configuration block.
Specify a specific address with the no form of the command and the netflow keyword to remove the explicit efc source netflow configuration statement for that particular Netflow source from the active measurement group configuration block.
Use the no form of the command with the monitor keyword to remove the explicit efc source monitor configuration statement from the active measurement group configuration block.
For more information about EFC, see Chapter 2: Collecting Endpoint Addresses of the CNA Basic Monitoring Guide.
|
|
|