DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Add IP Solutions

Install the Circuit Packs

Return to Task List


Caution! When adding or replacing any hardware, be sure to ground yourself against electrostatic discharge (ESD) by wearing a grounded wrist strap.


Note: The TN799B/C and TN2302AP circuit packs are hot-swappable, so you do not need to power down the carrier to install them.

If replacing the existing TN799B/C circuit pack, remove it first and replace it with the new TN799DP.

  1. Insert the TN799x circuit pack into the port slot identified earlier.


Note: To properly seat the circuit pack, push firmly on the front of the faceplate until the latch reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.

  1. Insert the TN2302AP IP Media Processor into the port slot you reserved for it and seat it properly (See TN2302AP IP Interface faceplate).

    2. When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED LED stays on until an IP address is assigned to the circuit pack.

  2. Type list configuration all and press Enter to verify that the system recognizes the TN2302AP circuit packs.

TN2302AP IP Interface faceplate

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.