DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Add IP Solutions

Administer the IP Interface

Return to Task List

Administration is done either locally or remotely. If administered locally, proceed with the following administration steps. If administered remotely, call your service representative to start the process.

  1. Log in as craft.


Note: If you have a dadmin login and password, you can use them instead of craft and the craft password.

  1. Type change circuit-pack and press Enter.

  2. In Circuit Packs - Screen 1, check the Code column to see if the slots above the TN802B says DSMAPD or MedPro.

  3. If MEDPRO, go to the entry just above the TN802B that says MEDPRO.

  4. Type DSMAPD, and press Enter. Changing the one entry automatically changes the entry above it. If it is in IP Trunk mode, you get the following error message:

 MedPro type requires TN802 with application. Type MEDPRO on 
circuit-packs form.

Circuit Packs - Screen 1

 change circuit-packs                                          Page   1 of   5 
                               CIRCUIT PACKS                                     
 
         Cabinet: 1                            Carrier: A
                                          Carrier Type: processor        
 
  Slot Code  Sf Mode   Name               Slot Code  Sf Mode   Name
                                           11:  MEDPRO      RESERVED-IP
 01: TN754         DIGITAL LINE             12:  MEDPRO      RESERVED-IP
 02: TN758         POOLED MODEM             13:  TN802  B      MAPD BOARD
 03: TN2144       ANALOG LINE              14: 
 04: TN746  B     ANALOG LINE              15: 
 05                                        16:         
 06: TN771  C     MAINTENANCE/TEST  
 07: TN464  F     DS1 INTERFACE     
 08: TN2140       E&M TIE TRUNK     
 09: TN767  E     DS1 INTERFACE     
 10: TN799  B     CONTROL-LAN       
 
   '#' indicates circuit pack conflict.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.