DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Install Additional Hardware

Configuring the system for the TN2501AP

  1. At the SAT, type list configuration board  board-location and press Return.

    2. The System Configuration report appears. Use this report to ensure that the switch recognizes the TN2501AP circuit pack after it is latched in the carrier slot.

  2. Verify the following field values:

  3. At the SAT, type change node-names ip and press Return.

    4. The IP Node Names screen appears. Use this screen to administer the circuit pack's node name.

  4. Type a unique name in the Name field.

    5. This name is recognized only within the switch, and does not need to match the node name on your network.

  5. Enter the IP Address.

    6. You can get this information from the network manager.

  6. Press Enter to save the changes.

  7. Type change ip-interfaces and press Return.

    8. The IP Interfaces screen appears. Use this screen to administer an IP interface, which associates the circuit pack with an IP address.

  8. Set the Enable Eth Pt field to y.

  9. Set the Type field to VAL.

  10. Type the circuit pack location in the Slot field (UUCSS).

    11. If a TN2501AP circuit pack is not at this location when you submit the screen, the system prompts you to enter a VAL circuit pack location.

  11. In the Node Name field, enter the Node Name you entered in step 4.

    12. If you press Help, a list of administered node names appears (including the name you administered with the change node-names ip command), and you can select from the list.

  12. Set the Subnet Mask field according to your network requirements.

    13. Gateway Address is usually the same as the TN2501AP circuit pack's IP address, usually with the fourth octet changed. Be sure to set this address according to your network requirements.

  13. Press Enter to save the changes.

  14. Type add data-module extension and press RETURN.

    15. The Data Module screen appears. Use this screen to administer the data module that is associated with the TN2501AP ethernet port.

  15. Set the Type field to ethernet.

  16. Set the Port field to correspond to the circuit pack location.

    17. The port number (final two digits) is always 33 for the TN2501AP circuit pack.

  17. Set the Link field to an unassigned or next-available link number.

  18. Set the Network uses 1's for Broadcast Address field according to the your network requirements.

  19. Type a unique name in the Name field.

  20. Press Enter to save your changes.

  21. If your system uses IP routing, type add ip-route and press Return.

  22. Administer IP routes to the TN2501AP circuit pack and press Enter to save your changes.

  23. Use the ping and status link commands to test the new IP connections that you have administered.

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.